Design tool

Schematic, board and 3D side by side

The three views at once — a part picked in one is highlighted in the other two.

U1 picked on the sheet, boxed and labelled in the 3D view of h730duino

View › Schematic | PCB | 3D splits the window into the sheet, the board and its 3D model. Pick a part anywhere and the other views ring it — panning to it when it is off screen — linked by designator. In 3D, a click picks the part under the cursor, and the Properties panel shows it with Frame in 3D and Select on board.

What it does

Cross-probing

A highlight, not a selection: nothing moves, nothing is deselected.

Units understood

U1A and U1B on the sheet probe U1 on the board.

3D that stays open

It shows the board you worked on last, so clicking the sheet does not close it.

Panels follow you

Properties, Layers and Library follow the view you work in.

The three questions that need two views

Which of these resistors is R14 on the sheet? What is that tall part next to the connector? Does the footprint I just moved collide in 3D? View ▸ Schematic | PCB | 3D splits the centre of the window into the sheet, the board and its 3D model, and documents you open afterwards go into the column you are working in. View ▸ Views as Tabs puts them back, and either layout is kept for the next session.

A highlight, not a selection

Pick a symbol and the board rings its footprint while 3D boxes the part and labels it; pick a footprint or click a part in 3D and the others follow. Nothing on the other views is selected or moved, and their own selection is left alone. A view pans to an off-screen part but keeps your zoom; only the view you are working in speaks, and a view never pans to its own probe.

3D with its own Properties

With the 3D view in front, Properties shows the picked part — designator, value, footprint, side, position, rotation, body size and where its height came from, and its 3D model or "file not found" — with Frame in 3D and Select on board. The same page sets the board's look: solder mask colour, ENIG, HASL or bare copper, the assembly layer and pin 1 highlighting. While you drag a footprint, 3D follows every frame.

The details

LayoutsSchematic | PCB | 3D in three columns, or views as tabs
Linked byDesignator — units U1A and U1B probe U1
SettingsPreferences ▸ Workspace: cross-probe between views; bring a probed part into view
3D board lookMask colour · ENIG, HASL or bare copper · assembly layer · pin 1

How to start

  1. Open a project with a sheet and a board.
  2. Choose View › Schematic | PCB | 3D.
  3. Click a part in any view; turn probing off in Preferences › Workspace if you prefer.

Questions

Will clicking the sheet close the 3D view?

No. The 3D view always shows the board you are working on, or the last one you worked on.

Can I turn cross-probing off?

Yes, in Preferences ▸ Workspace, together with the switch that pans a probed part into view.

How do I get the old layout back?

View ▸ Views as Tabs, or Preferences ▸ Reset to Default Layout for the factory one.