Fabrication export
Gerber RS-274X, Excellon drill, BOM and PDF — checked in the built-in Gerber viewer.
One dialog writes everything a fab and an assembler need: Gerber layers, drill files, a BOM and PDF documentation, with options for solder-mask swell, tented vias and netlist attributes. Inspect the files in the built-in Gerber viewer before you upload them.
What it does
Gerber and drill
RS-274X copper, mask, silk and outline layers plus Excellon drill files.
BOM
Designator, value, footprint and side — grouped or one line per part.
PDF output
Schematic PDF with title block, and per-layer PDFs for hobbyist toner transfer.
Gerber viewer
Open what you exported and look at it layer by layer before ordering.
Read back by the same parser that audits it
The worst class of fabrication bug is one where the editor and the exporter disagree: the board is right on screen and wrong in the file. WireFrame closes that gap by reading its own output back — the exported Gerbers go through the same parser as the built-in viewer, and the result is what the DFM checks run against. What you inspect before you upload is the file, not the intention behind it.
One package, everything the fab and the assembler need
Gerber RS-274X with apertures embedded, Excellon drill files with plated and non-plated holes separated, a drill report, a BOM, a pick-and-place file with rotations in the convention the assembler expects, IPC-D-356A netlist for electrical test, and a PDF for the human who will look at it. Exported together, named consistently, zipped.
Check it where the mistakes are
The built-in viewer draws the real apertures from the real files, layer by layer. Most fabrication mistakes are visible in ten seconds in a viewer and invisible in a file listing — a missing layer, a mirrored bottom, a soldermask that opened nothing.
The details
| Gerber | RS-274X with embedded apertures and X2 attributes; one file per layer, with the Protel-style names fabs expect (.GTL, .GBL, .GTO…) |
|---|---|
| Drill | Excellon, plated and non-plated holes in separate files, plus a drill report |
| Assembly | BOM as CSV, pick-and-place with X/Y/rotation/side, and a PDF assembly drawing |
| Test | IPC-D-356A netlist for electrical test |
| Exchange | IPC-2581 and ODB++, each optional |
| Verification | After export the package is read back — Gerbers, drills, CSVs and the PDF — by WireFrame's own parsers |
How to start
- Run the DFM check and fix what it finds.
- Open the Fabrication dialog from File › Export and choose the outputs.
- Open the result in the Gerber viewer, then zip and upload to your fab.
Questions
Which fabs accept these files?
RS-274X and Excellon are what essentially every PCB fab takes, and the files carry the Protel-style names (.GTL, .GBL, .GKO…) that prototype fabs recognise on upload.
Is the Gerber viewer separate from the editor?
It is built in, and it is the same parser the DFM checks use. That is the point: the viewer is not a second opinion, it is the one that matters.
Can I choose what goes in the package?
Yes — the BOM, pick-and-place, assembly PDF, drill report, IPC-D-356A netlist, IPC-2581 and ODB++ are each a switch, set before anything is written.