Design tool

DRC & DFM checks

Design-rule and manufacturability checks that jump straight to each problem.

DFM and DRC check on the hexapod robot board

Before you order boards, the DFM and DRC checks look for unconnected nets, clearance violations, traces narrower than their net class, drills your fab cannot make, copper too close to the board edge and overlapping parts. Each result takes you to the spot on the board.

What it does

Errors and warnings

Errors are what a fab would reject; warnings are for review.

Rules from your net classes

Minimum widths and clearances come from the design rules you set.

Jump, fix, re-run

Click a violation to zoom to it and fix it; the check runs again on its own.

Ready for the fab

The Fabrication dialog runs the check before it writes Gerber and drill files.

Design rules and manufacturability are different questions

DRC asks whether the board breaks its own rules: clearances, track widths, via sizes, unrouted nets, copper too close to the board edge. DFM asks whether a fab can actually build it: annular rings too thin to survive drill registration, holes closer together than the drill can place them, solder mask bridges too narrow to hold, thermal reliefs starved of copper, parts whose courtyards overlap. Passing one tells you nothing about the other, so WireFrame runs both and keeps them separate.

Every result goes somewhere

A result that says "clearance violation" and nothing else is a search task, not a finding. Each one here carries the rule that produced it, the two objects involved, the measured value and the required value — 0.17 mm where the class requires 0.20 — and clicking it zooms the canvas to the spot.

Checked before the files, not after

The most expensive mistake in this part of the process is exporting a board that passes DRC in the editor and fails at the fab because the Gerber says something slightly different. WireFrame runs the checks on the geometry the exporter will write, and then reads its own Gerber back with its own parser before you upload it. What the fab receives has been checked as the fab will see it.

The details

DRC checksClearance, copper to board edge, track width, via diameter, drill size, unconnected items, dangling tracks and vias, intersecting zones, missing footprints
DFM checksAnnular ring, hole-to-hole spacing, solder mask bridge, starved thermal relief, overlapping courtyards
ScopeThe whole board, checked again on its own a moment after each edit
OutputOne list, errors first, each item with its measured and required value; click to zoom to it
ExceptionsRight-click a result to make its rule a warning or an error; accepting a single item is not in the application yet

How to start

  1. Open the DFM & DRC Check panel (Tools › DFM Check).
  2. Press Run DFM Analysis and click each result.
  3. Re-run until the list is clean, then export.

Questions

Does DRC run while I route?

Clearance is marked live as you draw, and the full check runs again on its own a moment after each edit, so the list is current whenever you look at it.

Whose manufacturing limits does the DFM check use?

The design rules you set. Start from a fab preset — Relaxed, Standard, Fine pitch or HDI — then tighten or loosen the values to match the fab you actually use.

Can I ignore a finding I have decided is fine?

Not one item at a time yet. Right-click a result to turn its rule into a warning — or back into an error — for the whole board.