AI Copilot

/fix — repair one part

Say what is wrong with a part; get a proposed correction that changes nothing until you accept.

/fix U2 the package is SOT-23-3, see the datasheet

A repaired part waiting for you: the pad and pin check, the land pattern measured from the datasheet, and Confirm this component

When a part is wrong — package, pin map, value — describe it in a sentence and attach a datasheet if you have one. The Copilot proposes a correction with its evidence. Accepting it is a normal edit, and the decision is remembered so a later run does not undo it.

What it does

One part at a time

A focused repair, not a redraw of the whole design.

Evidence attached

The proposal shows the datasheet page or rule it relies on.

Your call

Choices such as the package suffix or the value are presented, not made for you.

Remembered

An applied fix is stored as a project decision.

Describe it the way you would to a colleague

/fix takes a designator and a sentence: "/fix J1 this is a 2-pin 2.54 mm header, not a screw terminal", "/fix SW1 its symbol points at a footprint we do not have", "/fix U1 connect pin 2 to SW and pin 3 to GND". Add the path of a datasheet at the end when you have one. If several checks disagree about the same part, it asks which problem you mean rather than picking one.

Nothing changes until you press Apply

The answer is what the Copilot would change, validated against the datasheet it downloaded and the package rules before you see it, with Apply, Attach datasheet and Cancel. Applying writes the symbol and footprint to the project library, replays the drawing in the editor and checks the card again.

A decision that stays made

An applied repair is recorded in project memory, so a later run of the Copilot does not quietly put the old part back. On a drawn schematic the same applies to the edits you make by hand: the repair and wiring agents are told what you changed and are instructed never to undo it.

The details

Form/fix <refdes> <what is wrong> [datasheet.pdf]
ScopeOne part per request
EvidenceThe PDF you attach, then the published index, then a datasheet WireFrame downloads
ButtonsApply · Attach datasheet… · Cancel
Recorded asA project decision, kept across sessions

How to start

  1. Type /fix followed by the designator and what is wrong.
  2. Attach the datasheet if you have it.
  3. Read the proposal and accept or reject it.

Questions

How do I see everything that is wrong, not one part?

/findings lists what WireFrame's own checks found across the design, at no model cost; /issues numbers the review findings so you can answer "fix 2" or "accept 3 because the LED is decorative".

What if it keeps the wrong package?

Attach the exact manufacturer datasheet and ask again — a clean datasheet is the best evidence there is.

Do I need a paid plan?

It comes with the Max and Pro plans, on the plan's monthly AI credit. The Free plan has the design tools and no AI Copilot.