SPICE in the loop
Simulate the drafted design right away, so a supply or filter that fails is caught before layout.
Simulate the 3.3 V rail at 300 mA load
A schematic can look right and still not work. Right after the Copilot drafts a design, the circuit can be simulated — a regulator's output, a filter's corner frequency — and the waveform shown before you start layout.
What it does
Before layout
Problems surface while they are still cheap to fix.
Real engine
The same ngspice-based simulation you can run yourself.
Readable result
Waveforms open in the viewer with cursors, not as a paragraph.
Your models
Uses the SPICE models in your libraries.
Know what can run before you ask
/sim-blocks lists the circuits of the simulation in front, which can run and what each is missing — without a model call. /sim then runs one block, the block holding a part (/sim U1) or every block that can run, and reports what it measured against the testbench; /sim board puts the routed board's copper in series with each supply.
Corners, not just the typical case
/corners runs the testbench at the ends of every part's tolerance and at −40, 25 and 85 °C, each part pushed in its own worst direction. A design that only works at 25 °C is not finished, and this is the quickest way to find out which one yours is.
Models you can trust
A part with no model cannot be simulated honestly. /model finds the manufacturer's model, downloads it and wires it to the symbol's pins, uses one you have, or with draft builds one from the datasheet's numbers. /verify-model then measures the model the way the datasheet measures the part, at the table's own conditions, and says number by number whether the model is the part.
When a run fails
/sim-why reads the engine log and the netlist deck and says why the last run failed; /sim-explain says what the waveforms — or one signal — mean against the testbench. The answers are explanations to check against the log and the circuit, not a replacement for reading them.
The details
| Commands | /sim-blocks · /sim [N | U1 | all] [board] · /corners · /sim-why · /sim-explain [NET] · /model · /verify-model |
|---|---|
| Model calls | /sim-blocks: none |
| Temperatures | −40 / 25 / 85 °C, with every part at its own worst tolerance |
| Engine | The same ngspice the workbench runs |
| Where | With a simulation (.simxml) in front of the chat |
How to start
- Draft or open a design.
- Copy a block into a simulation and run it, or ask the Copilot from the simulation workbench (/sim).
- Read the waveform; adjust values and run again.
Questions
Can it simulate my whole design?
Simulations are made of blocks copied from the sheets, one circuit per simulation. Copy the block you care about — a regulator, a filter, a timer — and simulate that.
What if a part has no SPICE model?
/model looks for the manufacturer's, or drafts one from the datasheet; /verify-model then tells you how closely the model matches the datasheet before you rely on it.
Do I need a paid plan?
It comes with the Max and Pro plans, on the plan's monthly AI credit. The Free plan has the design tools and no AI Copilot.