PCB design, AI & WireFrame
Practical guides on board design, high-speed routing, moving from KiCad, sample boards and AI-assisted electronics.

KiCad to WireFrame EDA and back: 72/72 round trips identical
Open a KiCad project in WireFrame EDA, work on it and export it back to KiCad: what comes across, what to check, and how the round trip was measured.

Sample board One-Air-Max — a 4-layer ESP32-C6 air-quality sensor with a PCB antenna, in WireFrame EDA
KiCad's One-Air-Max demo (ESP32-C6, solar and battery charging, buck converter, sensor front-end) imported into WireFrame EDA — its four-layer stackup and the keepout that keeps copper away from the antenna.

Sample board KLP4e MCU datalogger — reading a finished schematic, and what ERC says about it
The ATmega328P datalogger from "KiCad Like a Pro" (4th ed.), imported into WireFrame EDA — its two schematic sheets, why a working design still shows 18 ERC errors, and the small two-layer board.

Sample board Jetson Nano baseboard — an 8-layer SO-DIMM carrier, opened in WireFrame EDA
Antmicro's open-source baseboard for the Jetson Nano and Xavier NX modules, imported from KiCad into WireFrame EDA — what is on its eight layers and what WireFrame measures on it.

Sample board Jetson AGX Thor baseboard — 10 layers and 1124 parts, opened in WireFrame EDA
Antmicro's open-source carrier for the NVIDIA Jetson AGX Thor module, imported from KiCad into WireFrame EDA — its ten-layer stackup, length-tuned camera pairs and the numbers WireFrame measures on it.

How WireFrame finds the right part for every BOM row
Where WireFrame looks for a symbol and land pattern, the checks every candidate must pass, why a part you confirm is reused on the next board — and how the AI Copilot reads the same library instead of guessing.

Sample board CM5 Minima — a 6-layer Raspberry Pi CM5 carrier, in 2D and 3D in WireFrame EDA
The CM5 Minima carrier for the Raspberry Pi Compute Module 5, from KiCad's demo projects, imported into WireFrame EDA — four inner planes, an M.2 slot, and the parts drawn from their 3D models.

Sample board automotive buck converter — 12 V to 5 V on two layers, in WireFrame EDA
A small open-source MAX17574 buck converter for 12 V vehicles, imported from KiCad into WireFrame EDA — fully routed, ground poured on both sides, clean DRC, and what to look at on a board this size.

Sample board H730duino — a 4-layer STM32H730 Arduino Mega-format board, opened in WireFrame EDA
Opening the open-source KiCad project H730duino (STM32H730, Ethernet, HyperRAM, USB-C) in WireFrame EDA to read its 4-layer stackup, GND/3V3 planes, length-matched meanders and board metrics.

Moving a KiCad project to WireFrame EDA — libraries, schematics and PCB
How to open a KiCad project (.kicad_pro) in WireFrame EDA, reuse your KiCad symbol and footprint libraries, and what to check after the move.